TRUCK REPAIRS SHOP(855) 450-1212 · Mobile + shop network 24/7

Why is my equipment latch continuously locking and unlocking while raising?

2026-11

Call (855) 450-1212Request service

What was reported

["latch repeatedly locking and unlocking while raising","electrical wiring harness issue"]

Our answer

When a hydraulic lift or powered tailgate latch continuously locks and unlocks while the gate is being raised, the issue is almost always electrical. The most common cause is a chafed, pinched, or shorted wire within the electrical harness that energizes the latch solenoid whenever the lift circuit is activated. As the gate moves, tension or flexing in the wiring harness can cause intermittent short circuits to power or ground, cycling the latch mechanism repeatedly. Other potential causes include a failing latch control switch, loose or corroded ground wires, or a faulty control relay.

Before calling for emergency service, inspect the wiring harness along its full length, especially near pivot points where the harness flexes during operation. Look for visible wire damage, broken insulation, or pinched lines. Check that all electrical grounds are clean, tight, and free of rust or corrosion. If visual checks do not reveal the problem, a mobile technician will need to test circuit continuity with a multimeter, isolate sections of the harness, and repair or re-pin damaged wiring to restore safe operation.

What the technician found

Restored up and down movement, but latch continuously unlocked while raising; identified suspected electrical harness short requiring tracing.

How it ended

unknown

More real calls

Written up from real calls to our dispatch line. Names, phone numbers and exact locations are left out.

Why won't my Kenworth parking brake valve push in to release the brakes when I have full air pressure?

Kenworth · Richmond, · 2026-11

When a yellow parking brake valve will not push in or release the brakes despite having full system air pressure, the issue often stems from a faulty dash control valve, a bad inversion valve, or a stuck spring brake relay valve. Since the truck recently came…

Why are my semi truck parking and trailer brake valves refusing to release when I have plenty of air pressure?

2026-11

When your semi-truck parking and trailer brake control valves won't release despite showing full air pressure on your dash gauges, the issue is often related to a faulty valve assembly, line restriction, or mechanical binding. The primary culprit is usually a…

Why does my Kenworth yellow parking brake knob have no air supply while the red trailer knob works?

Kenworth · 2026-11

When a Kenworth trailer knob charges properly but the yellow parking brake knob has no air supply, the issue typically points to a failed dash push-pull control valve block, an internal manifold seal failure, or a disconnected supply line behind the dashboard…

Why is my semi truck air leaking or failing at the dash valve when both supply lines have pressure?

2026-11

When both primary and secondary air supply lines deliver full pressure up to the dash control valve but the system fails to hold pressure or operate properly, the internal seals within the dash control valve assembly have likely degraded. The dash brake valve…

What should I do if my air lines wrapped around my tire and snapped the air valve off the back of the cab?

2026-11

When pigtails or air hoses drop and catch on a spinning drive tire or driveshaft, the extreme force will yank the hoses and snap whatever mounting hardware or valve assembly secures them to the back of the tractor cab. Replacing just the red and blue coiled s…

All real calls

Truck Repairs Shop is a service of MTS Mobile Truck Repair Service LLC, dispatching mobile mechanics, heavy-duty shops and wreckers across the United States and Canada, 24/7. · (855) 450-1212 · Request a quote · Local numbers · Real calls · mtstruckservice.com

Call (855) 450-1212Request