TRUCK REPAIRS SHOP(855) 450-1212 · Mobile + shop network 24/7

Why are my trailer running lights and strobe lights not working when brake and turn signals work?

2026-11

Call (855) 450-1212Request service

What was reported

["trailer running lights not working","trailer strobe lights not working","brake lights and signal lights working"]

Our answer

When a trailer's brake lights and turn signals work fine but the running lights and strobe lights fail to illuminate, the issue usually points to the specific tail and marker light circuit rather than a main ground failure. The most common cause is a loose, corroded, or damaged pin on the seven-way electrical cord or tractor receptacle, specifically the pin dedicated to the clearance and running light circuit. Another frequent culprit is a blown fuse or tripped circuit breaker in the tractor fuse panel powering the trailer marker light circuit. Wiring harness damage, such as a pinched or chaffed wire running along the trailer frame, or corrosion inside a junction box feeding the running and strobe light circuits can also cut power to those specific lights. As a driver, start by inspecting the seven-way plug and receptacle for green corrosion, bent pins, or loose fit. Try wiggling the cord while someone watches the lights, or swap in a spare seven-way cord if available. Next, check the tractor fuse box for any blown fuses corresponding to trailer clearance or tail lights. If the plug and fuses look good, a mobile technician will need to trace the wiring with a multimeter or circuit tester to locate open circuits, shorted wires, or bad connections along the trailer chassis.

What the technician found

Cause not confirmed on the call

How it ended

unknown

More real calls

Written up from real calls to our dispatch line. Names, phone numbers and exact locations are left out.

Why won't my Kenworth parking brake valve push in to release the brakes when I have full air pressure?

Kenworth · Richmond, · 2026-11

When a yellow parking brake valve will not push in or release the brakes despite having full system air pressure, the issue often stems from a faulty dash control valve, a bad inversion valve, or a stuck spring brake relay valve. Since the truck recently came…

Why are my semi truck parking and trailer brake valves refusing to release when I have plenty of air pressure?

2026-11

When your semi-truck parking and trailer brake control valves won't release despite showing full air pressure on your dash gauges, the issue is often related to a faulty valve assembly, line restriction, or mechanical binding. The primary culprit is usually a…

Why does my Kenworth yellow parking brake knob have no air supply while the red trailer knob works?

Kenworth · 2026-11

When a Kenworth trailer knob charges properly but the yellow parking brake knob has no air supply, the issue typically points to a failed dash push-pull control valve block, an internal manifold seal failure, or a disconnected supply line behind the dashboard…

Why is my semi truck air leaking or failing at the dash valve when both supply lines have pressure?

2026-11

When both primary and secondary air supply lines deliver full pressure up to the dash control valve but the system fails to hold pressure or operate properly, the internal seals within the dash control valve assembly have likely degraded. The dash brake valve…

What should I do if my air lines wrapped around my tire and snapped the air valve off the back of the cab?

2026-11

When pigtails or air hoses drop and catch on a spinning drive tire or driveshaft, the extreme force will yank the hoses and snap whatever mounting hardware or valve assembly secures them to the back of the tractor cab. Replacing just the red and blue coiled s…

All real calls

Truck Repairs Shop is a service of MTS Mobile Truck Repair Service LLC, dispatching mobile mechanics, heavy-duty shops and wreckers across the United States and Canada, 24/7. · (855) 450-1212 · Request a quote · Local numbers · Real calls · mtstruckservice.com

Call (855) 450-1212Request